Fix and Reset

Tire pressure sensor fault or Service Tire Monitor System message

Breadcrumb: Home / Fix and Reset / Sensor Fault. Last updated: [current date]. By the Tire Pressure Light editorial team. Quick Answer: A "Service Tire Monitor System" or sensor fault message means the TPMS has detected a communication or hardware problem. It is not always a low-pressure warning. The most common causes are a dead sensor battery, a damaged or corroded sensor, or a receiver fault. Check the tire pressures by hand first, then have the system scanned by a qualified technician to identify the failing sensor.

Table of contents: What the message means | Why sensors fail | Blinking light versus solid message | What to do next | Replacement and cost expectations

What the message means

The TPMS receiver in your car listens for radio signals from a small sensor inside each tire. When it stops receiving a valid signal from one or more sensors, or detects a fault in its own module, the dashboard shows a system message instead of a simple pressure reading. This means the system cannot confirm pressure at every wheel, even if the tires look normal.

Why sensors fail

Most TPMS sensors run on a small battery sealed inside the unit, typically lasting several years. Over time that battery weakens. Physical damage from tire mounting, road debris, corrosion at the valve stem, and faults in the receiver can also stop a sensor from transmitting.

Blinking light versus a solid message

A blinking TPMS light that cycles several times at startup and then stays on usually points to a system fault rather than low pressure. A written message such as "Service Tire Monitor System" points the same way. Note which wheel, if any, the message names, and check that tire first.

What to do next

Check all four tire pressures when the tires are cold, using the pressure listed on the driver door placard. Confirm that the valve caps are on and tight. Then book a diagnostic scan with a qualified tire shop or dealer, which can read each sensor ID and show which one is not reporting.

Replacement and cost expectations

If a sensor has failed, replacement is usually required rather than a reset. Costs vary by vehicle, sensor type, and whether the tire must be removed. Get a written quote that lists the sensor part, labor, and any reprogramming fee before you agree to the work.

Frequently asked

Can I drive on a Service Tire Monitor System message? Generally yes for short trips while you arrange a scan, but keep tires inflated to the correct pressure and get the system checked soon.

Tire Pressure Light editorial team